I'm new in the site. I have a AEM Wide Belt Sander Machine Model: 501-37. It has a Meldas 50M controller. Machinery Manuals & Brochures; Member and Shop Photos.

In the operator manual, there should be a list of alarms. For the M01 alarm, there are various conditions associated with it, the 0006 X is the key here. On the Meldas 3 control there is about 15 conditions, so I expect that yours would be very similar. If you don't have a manual, I am not sure what you have available where you are located. Our USA phone number is 1-847-478-2500 and they are very helpful and free. They have lots of info on their web sites around the world. In the US it is meau.com.

Thanks Bill for the replay. I have the operation manual, and it says that H/W Stroke End has been activated, if I understand is in the X axis, but in this axis I don't have any limit switch or sensor I only have one in Z axis. I can ignore this error in R156 but the machine still isn't move.

You think that is parameters problem or there are some wrong with the controller. **** It may be additional R bits that need to be set to prevent the open contact condition from actually causing an alarm.**** Do you know how can I see the start sequence program for the controller.

SURVEY: ArtCam 2012 has worked for you with the crack provided? Sage act pro 2012 full windows version. Bellow is the download link: ========================== Link 1: ==========================. After that run it and use it. Please enjoy your visit here and do not hesitate to search another cracked programs or apps for you. 1934 Votes for YES Steps: • Just mount the iso file with Daemon Tools or Power ISO or what program o you have for image • Run the installer • After installation is finished copy the crack from the crack folder in your installation folder ( you know the drill) • Run the software Simple as that.

**** there may be an R bit or software switch that will enable the display***** Regards Pablo'Why when I try to monitoring the ladder program that I wrote, only can monitoring the Inputs but not the outputs. ' **** try hitting page down key, or possibly the rightmost key under the monitor.**** Bill.

I could fix the error, but I still continous without monitoring the outputs, and I can't put it in servo ready, I can move the axis. The inputs do not respond according to the system, if I put the system in handle the input X1E1 and the output Y209 do not turn 1; why???? How can I program it to do this???

Where can I find this manual, Meldas 50M PLC Interface Manual Or which Meldas is similar to Meldas 50M? Where can I find a manual for the plc, FCA50M????The US website is: meau.com.

If the ladder is not running, the output bits will all be off.

Hi everyone, I'm having some trouble with my 'new' Mori TV-30. The machine was fully functional but lost the absolute positioning after backup battery failure.

It comes up with the following errors: Z70 'ABS illegal Error' 0101 XYZ2 M01 'Operation error' S52 Servo Alarm Oil Pressure low (Machine Mori Seiki TV-30 APC, MSC 802/Meldas 50M) I'm unfamiliar with the Meldas Control and somewhat stuck. The manual says that these need a new zero point adjustment, and I have the procedure detailed in the manual.

Z axis zero point should be set with a 250mm gauge block between the spindle nose and table, not subtable. Any ideas on what I should use as the reference table?